# Encryption # To protect privacy, everything is encrypted with the strongest encryption available. The reasons for selecting the algorithms were: ## Key Exchange and Signatures ## * RSA: Reasonable (128bit) strength requires at least 3kbit key size; factoring is not as hard as originally assumed; the algorithm are still above polynomial, but way below brute force, and any further breakthrough will require to increase the key size to unreasonable limits. With a 4kbit key (512 bytes per key), the connection setup information won't fit into the 1kB packets. * Diffie-Hellman discrete logarithm has essentially the same strength as RSA. * Elliptic Curve Cryptography is still considered "strong", i.e. there is only the very generic big/little step attack, which means a 256 bit key equals 128 bit strength. The selection therefore was Ed25519, a Edwards form variant of Dan Bernstein's curve25519. Edwards form is notationally simpler and regular than other curves, allowing more optimizations. The parameters of this curve are known-good, following the "nothing up my sleeve" principle. ### Key Exchange Procedure ### The first phase of a key exchange uses ephemeral (one-time) keys. Let's call the initiator Alice, and the connected device Bob: 1. Alice generates a key pair, and sends Bob the public key, together with a connection request. 1. Bob creates a key pair and sends Alice the public key. Using this public and secret key, he generates a shared secret1, and uses that to encrypt his permanent public key (used for authentication). An attacker can see the ephemeral key, but not the permanent pubkey. Bob puts his state in an encrypted string where only Bob knows the key, and sends this "ticket" back to Alice. Receiving the ticket will actually open up the connection. 1. Alice receives both keys and can now create two shared secrets: secret1 is the ephemeral secret, secret2 is the authentication secret. She sends her authentication pubkey back to Bob encrypted with secret1. This allows Bob to compute secret2. Furthermore, Alice sends back Bob's ticket and a random per-connection seed for the symmetric keys; the ticket can be (in theory) used to open several connections to Bob with a single packet (no reply required). The general formula for ECC Diffie-Hellman key exchange is _secret = pk1\*(sk2) = pk2\*(sk1)_. For secret2, I modify this to avoid side-channel attacks in the lengthy curve point computation, and use _secret2 = pka\*(skb\*secret1) = pkb\*(ska\*secret1)_. The scalar multiplication in mod _l_ (the number of curve points) is much faster than the curve point computation, and is much less likely to leak information. ## Symmetric Crypto ## The requirement is AEAD: Authenticate and encrypt/decrypt together. Candidates were: * AES in CGM — this has two problems. 1. CGM is not a secure hash, and the GF(2^n) field used gives security level of only about 64 bits for 128 bits checksum. 2. AES uses a constant key, and therefore, side-channel attacks are more likely to succeed. * xsalsa/salsa20+poly1305: This uses a stream cipher and a GF(p) polynom, which provides full 128 bit security for the 128 bit checksum, but the security of the checksum depends on the encryption. There's a low risk that the proof here is basing on wrong assumptions. As a stream cipher, there is no constant key, so side-channel attacks are more difficult. This combination wins over AES/CGM. * Keccak in duplex mode provides both encryption and strong authentication, which does not depend on the encryption. The checksum is a keyed plaintext checksum, so it actually protects the plain text, and proves knowledge of the key at the same time. Verification of the packet is possible without actually decrypting it (i.e. it _also_ is a ciphertext checksum). Strength is >256 bits, providing a very high margin. Furthermore, Keccak/SHA-3 is a universal crypto primitive, so everything needed for symmetric crypto is done with just one primitive. Keccak wins over xsalsa/salsa20+poly1305.